9 Pcs. Mitutoyo Made in Japan Brand New
Grade "AS-1" Rectangular Steel Gage Block Set,A Certificate of Accuracy, traceable to the NIST, is furnished with each Mitutoyo gage block set and individual block, All Mitutoyo gage blocks meet or exceed all known specifications. The flatness, parallelism and surface finish necessary to achieve the required accuracies are the same as or better than government requirements.
|Order No. ||Blocks |
|Grade ||Blocks Incl. In Set ||Remarks |
|516-935-26 ||9 ||AS-1 ||.0625", .100", 0.125", |
.200", .250", .300",
.500", 1", 2"
These gage blocks are intended for shop floor use to set and calibrate fixtures as well as precision instruments.
Precision gage blocks are the primary standards vital to dimensional quality control in the manufacture of parts. Mitutoyo offers a complete selection of gage blocks available in a choice of rectangular or square, metric or inch and steel or CERA (ceramic) types.
Gage blocks offered by an all-round precision measuring machine manufacturer, Mitutoyo, guarantee such a high accuracy that users can use them without anxiety. Needless to say, Mitutoyo has established a traceability system for our measurement products, up to the Metrology Management Center of the National Institute of Advanced Industrial Science and Technology (AIST) and we have been certified by the Japanese government as an accredited laboratory.
The lapping technique is one of Mitutoyo’s specialties. Our advanced lapping technique, developed for more than a half century, enables us to achieve the best flatness and surface roughness needed for gage blocks and realize a great wringing force.
Abrasion Resistance and Dimensional Stability
High-carbon high-chrome steel is employed to sufficiently satisfy a variety of material characteristics required for gage blocks. A high degree of hardness, obtained by our heat treatment technology and that reassures users, as well as methodically repeated heat treatment, have successfully reduced deterioration change over time to the minimum.
A Certificate of Inspection is furnished with all Mitutoyo gage blocks with a serial number on the case and an identification number on each block. The deviation of each block is registered. For this inspection, each gage block is measured relative to the upper level master using a gage block comparator. Grade K gage blocks are manufactured by absolute measurement using an interferometer. The gage block set and discrete gage block are supplied with a Certificate of Calibration. The Certificate of Calibration specifies the deviation from the nominal length. (Comparative measurement, however, is performed for all square gage blocks.)
A Certificate of Accuracy, traceable to the NIST, is furnished with each MITUTOYO gage block set and individual block