4 Pcs. Mitee-Bite Products LLC
Made in USA Brand New .400"(A) x .450"(B) x 3/8-16(Screw Size) Tool Steel Workholding Machinable Pitbull® Clamps-Holding Force 6,000 Lbs
The popular Pitbull® fixture clamp is now available in a machinable version. The clamp has positive down force and a very low gripping profile, making it well suited for machining pieces complete in one set up. The Machinable Pitbull® clamp is made of tool steel and heat treated to about 43RC for long life, yet still machinable.
There is additional material on the clamping face to allow for machining a radius. It is available in two sizes with 6,000 and 12,000 lbs (26,000 N. and 50,000 N.) of holding force. A dowel pin is included in each package to locate clamp while machining radius.
Machinable Pitbull® Instructions
- Machine a pocket to locate workpiece and pockets for clamps.
- If machining maximum amount from clamp use standard dimensions for "A" from chart. If machining less, adjust dimension accordingly.
- Assemble clamp without O-ring and install in fixture with dowel pin, under front edge of clamp as shown in diagram. Tighten securely and machine clamps for a slip fit with workpiece.
- Remove dowel pin, add O-ring and install clamp.
- Clamp is at approximately 43RC, carbide tooling is recommended for machining.
NOTE: Clamp can be machined concave or convex. However maximum recommended stock removal should be adhered to at center line of clamp.
Description | A | B | C | D | E | F | Slot Width | Screw Size | Max. Torque
| Total Holding Force | Total Throw | Dowel Pin |
---|
Tool Steel, Machinable | .400 | .450 | 1.00 | .250 | .710 | 1.075 | 1.00 | 3/8-16 | 30.0 Ft/Lbs | 6,000 Lbs | .050 | 1/8 |
These images shows how these Machinable Pitbull® Clamps can be used for application. You will only get described clamps, nothing else.